Topping | PC Image
Topping
Topping
Sort by
Show result
  • APX555B limited our measurement again
  • 4PIN XLR+4.4mm+6.35mm output
  • SE + BAL input pass through
RM1,169.00
RM1,399.00
  • Headphone amp/pre-amplifier application
  • Precise and matched
  • 2 Gain setting
  • NFCA Discrete modules
  • Dynamic Range
  • Output Power
RM2,399.00
  • Bluetooth 5.0 Trasmission
  • Auto Screen Close
  • Easy to Operate
  • Tablet and Phone Application
RM1,399.00
RM1,599.00
  • Support Highest DSD512(Native) and PCM 32Bit/768kHz
  • Bluetooth 5.0 LDAC transmission
  • 2*ESS ES9038Q2M SABRE HIFI DAC
  • THD+N as low as 0.00025%
  • XMOS XU208 and customized drivers
  • Auto on/off& Auto screen close
  • USB/Coaxial/Optical DAC application
  • DAC+Pre-amplifier/ Bluetooth receiver/Tablet and phone DAC application
RM899.00
  • Hi-Res Audio
  • Support DSD Direct Mode
  • Touch Operation    Preamp function
  • Remote Control
RM599.00
  • Headphone amp Preamplifier application
  • HiRes Audio
  • Ultra High performance NFCA Modules
  • 3 Level Gain Setting
RM599.00
  • Multiple format support
  • 10band EQ
  • Support airplay and DLNA
  • Two-way bluetooth function
  • Support 256GB TF Card
RM919.00
  • Hi-Res Audio
  • Bass & Treble EQ
  • 4x Digi & 2x Analog inputs
  • Custom setting memory
  • Built-in DAC
  • Remote Control
RM1,199.00
  • Material: single strand silver plated wire plus oxygen-free copper wire
  • Wire Category: RCA Interconnect Cable
  • Colour classification: red + black
  • Connector: Gold plating
  • Length: 0.25 meters
RM159.00
  • Wire using SGP-222
  • Conductor resistance: 26.9Ω/KM
  • Square number: 0.533MM²*2/19AWG*2
  • OD: 8MM
RM319.00
  • Wire using SGP-222
  • Conductor resistance: 26.9Ω/KM
  • Square number: 0.533MM²*2/19AWG*2
  • OD: 8MM
RM199.00
  • Wire using SGP-222
  • Wire inner core: 8*0.16MM 6N single crystal copper silver-plated wires + 180*0.08MM 6N single crystal copper
  • Conductor resistance: 26.9Ω/KM
  • Square number: 0.533MM2*2/19AWG*2
  • OD: 8MM
RM159.00
  • Wire using SGP-222
  • Wire inner core: 8*0.16MM 6N single crystal copper silver-plated wires + 180*0.08MM 6N single crystal copper
  • Conductor resistance: 26.9Ω/KM
  • Square number: 0.533MM2*2/19AWG*2
  • OD: 8MM
RM319.00
  • Headphone amp and pre-amp
  • 4-pin XLR, 4.4 balanced, and 6.35mm outputs
  • 3-step gain switch 
  • Can drive full-sized headphones and sensitive IEMs
  • NFCA modules
  • THD+N: <0.00006%
  • DNR: 145dB
  • Noise: <0.2uVrms
  • Output impedance: <0.1Ω
  • Maximum output power: 7600mW x2
RM2,199.00
  • Comfort zone with lowest distortion :The lowest THD+N of PA3s is in the range of 10-20W output, which happens to be the power range commonly used for listening to music. Everything is just in the right condition.
  • With the help of a DAC, the function is expanded to a greater extent :PA3s can be used with a DAC to expand the categories of digital inputs; if used with a DAC+HPA, more comprehen sive functions can be achieved.
  • Balanced + Single- ended inputs :PA3s provides TRS balanced input and RCA single: end- ed input. The u use of balanced input eliminates potential ground loop problems giving the pristinely clean audio without any hum.
  • High output power :PA3s could output 80W x2 at 4ohm load, 10% THD+N. In higher standard of THD+N of 1%,output power will be 65W x2 at 4ohm load. The output power is enough to drive any bookshelf speakers and even some floor speakers.
  • 2xMA12070 Fully balanced Class D amplifier :Each channel of PA3s uses one MA12070 Class D power amplifier chip. This allows separation in layout improving performance and reducing crosstalk. The power is shared across two chips, the heat dissipation is also halved for each chip, improving reliability and extending the lifespan of the product.
RM599.00